Hemming and sewing on lace (fig. 35) – SINGER 216G User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hemming and Sewing on Lace (Fig. 35)
Start the hem as previously explained and then when
the feed has caught the goods, lift the hemmer by
raising the presser bar lifter and being careful that
the goods does not slip out of the scroll. Then lead
the end of the lace through the slot in the right side
of the hemmer, so that the edge of the lace lays on
the hem. Now lower the presser bar.
Method of Making the Felled Seam (Figs. 36 and 37)
The two pieces of material, which are to be seamed
together,
are
placed
with the right sides
against
each
other
in
such
a
manner,
that the edge of the
lower
piece
extends
about 2 mm. (Vs")
beyond
the
upper
piece. Lead the two
pieces of goods into
the
seamer,
lower
it and make the first
seam (Fig. 36). Now
spread
the
work
apart
so that
it is
flat, and so that the
wrong sides are up,
and
then
lead
the
free
edge
of
the
seam into the seamer
and
sew,
as
shown
in Fig. 37.
Fig 37
Fig. 36
37