To alter the length of stitch, Reverse feed – SINGER 216G User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
require
changes.
Should
it
be
found
necessary
to,
change the bobbin thread tension, it can be regulated
by the screw (S, Fig. 15). Here again an increase in
tension is attained by turning the screw to the left.
To alter the Length of Stitch
By means of the stitch regulator, as shown in Fig. 23,
the
machine
can
pro
duce
stitches
between
0 and 4 mm. in length.
The
desired
length
of
stitch
is
attained
by
loosening
the
thumb
screw (A) and by press
ing
it
to
the
bottom
of the slot. The stitch
regulating
lever
(B)
is
then placed so that its
upper
side
is
in
line
with the number of the
desired
stitch
length.
Finally,
move
the
thumb
screw
(A)
back
up again until the stitch
regulating
plate
touches
the
lever,
then
tighten
the
screw.
The
machine
will
now
make
the
indicated
length of stitch in a forward direction.
Fig. 23
Stitch Setting Mechanism
Reverse Feed
The change from forward to reverse feed is brought
about by lifting the stitch regulating lever (B, Fig. 23),
which
is
pressed
downward
for
forward
feeding,
as
high as it will go, until it touches the top contact
point. The machine will then sew the same number
24