SINGER 216G User Manual
Page 57
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
fibre plate. For smaller holes us'e the spur plate with
3V4 mm. (Vs") spur (No. 3, Fig. 5) and adjust the
machine for left-hand needle vibration with a V
2
mm.
(Vis") width of bight, while for larger holes, the spur
plate with.
4
V
4
mm. (Vis") spur (No. 4, Fig. 5) is used
Fig. 63 Performing Madeira Work
and the width of bight is set at 2 mm. (Vs4").
Place the punched hole on the spur of the plate, and
draw
up
the
under
thread,
which
is
then
pressed
together with the upper thread for several stitches by
holding them against the material with the forefinger.
Move the material in the hoops around the spur in a
circular
direction
so
that
the
edge
of
the
hole
is
stitched over once only. To fasten the thread set the
machine
for
central
needle
position
with
the
bight
lever set at 0, and make a few stitches on the edge
of the hole by again slowly turning the hoop. For
sewing the next hole it is necessary to readjust the
machine for left-hand needle position and bight lever
set as it was before.
53