To remove the work, Thread tensions – SINGER 216G User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Do not pull the material along in order to aid the
feeding,
since
this
might
bend
the
needle
or
even
break it. The machine feeds without any assistance.
To Remove the Work
As soon as the thread take-up lever has reached its
highest
position,
raise
the
presser
foot,
draw
the
fabric back and to the left, pass the threads over the
thread cutter (F, Fig. 10) and pull lightly to sever
them. The ends of the threads are again placed under
the presser foot as described above in "To Commence
Sewing".
Thread Tensions
For
ordinary
sewing
the
interlocking
of
the
needle
and bobbin threads must take place in the middle of
the sewing work as shown below:
Fig. 19
Correct Sewing
E.754
If the tension on the needle thread is too tight or
the tension on the bobbin thread is too loose, then
the
needle
thread
will
lie
straight
along
the
upper
surface of the material as illustrated in Fig. 20.
Fig. 20
Too Tight Needle Thiead|
Tension or Too Loose Bob
bin Thread Tension
£//j/a
If the tension on the bobbin thread is too tight or
that of the needle thread is too loose, then the bobbin
thread will lie straight along the under-side of the
material, as shown in Fig. 21.
Fig. 21
Too Loose Needle Thread
Tension or Too Tight Bob
bin Thread Tension
rv
£/A3/9
22