Lower looper (red), Threading – SINGER 14T948DS User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Threading
Lower looper (red)
- Place the spool on the
spool holder pin.
- Bring thread up from back to front
through guide (1)
- Pull the thread under the protector (2)
and pass under the guider up to
go around the pre-tension (3)
- Thread guide (4,5,6)
- Turn the balance wheel
toward you until the lower
looper extending out
5-10mm from the needle
plate edge.
- Pull the thread
with tweezers to pass the
lower looper hole (A).
- Draw the thread with your
left hand tightly.
- Use your finger to push the
automatic threader (B) up to
the topmost,and then
thread goes through the
lower looper (C)
automatically.
19
Advertising