Tb la – SINGER 9618 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
tb
la
CHANGING PRESSER FEET
Snap-on Presser Feet
The presser feet furnished with your machine
snap on and off a common shank.
Raise needle to highest position by turning the
hand wheel
toward you.
Raise presser foot.
To Remove and Replace Foot
1 a. Press toe of presser foot upward as far as
it will go.
1 b. Then snap down to remove.
2.
Centre the new presser foot under the
shank A and
lower the presser foot lifter
so
that the shank fits the presser foot pin.
3.
Press presser foot screw down
firmly
until
foot snaps Into place.
CHANGING THE NEEDLE
•
Raise needle to its highest point by turning
the hand wheel
toward you.
Loosen needle
clamp screw B and remove the needle.
• Insert new needle up into clamp C as far as
it will go. with the flat side of the needle to
the back.
• Tighten needle clamp screw.
ATTACHING BLINDSTITCH
HEM GUIDE
•
Raise presser foot, loosen presser foot
screw with a coin and slip blindstitch hem
guide between screw and shank of the
general purpose foot.
•
Be sure underside of the guide clears the
slide plate and front of foot.
• Tighten screw with a coin.