SINGER 9618 - Manual (Page 71)

CLEANING YOUR MACHINE
CAUTION: Before cleaning your machine, dis­
connect power line plug from your socket out­
let.
With a soft cloth or lint brush, clean all points
indicated by arrows, especially the bobbin
case area and feed. Also, clean exposed parts.
If necessary a mild solution of soap and water
may be used to remove stubborn stains. No
other cleaning liquid or powder should be
used.
Periodically apply a drop of oil only to the
areas indicated after cleaning.
CAUTION: Do not attempt to adjust the motor
belt Drive. Refer to your nearest Singer Service
Centre should any adjustments be required.
REMOVING FACE
PLATE
Loosen screw D (do not remove).
Remove face plate screw E then remove face
plate by drawing it
toward you. Replace face
plate by sliding top edge of plate under edge
of arm top cover. Tighten screws E and D.
REPLACING SLIDE
PLATE
Place slide plate in slide way with the front
edge close to, but not covering, the retaining
spring F. With a small screwdriver, lift each
end of the spring into each of the side
grooves on the under slide plate. Draw the
slide plate gently
toward you to fully engage
the spring. Close slide plate.
69