SINGER 9618 - Manual (Page 65)

-- wsa A/\/\
0
•
2
•
4
•
6
Buttons
0
•
2
•
4
•
6
—'/ naaa A/X
0
•
2
•
4
•
6
ITn’innl/______________ _
• Pattern Selector; 1-2-3-4-5
• Needle Position: ¡¿»i«!» m»
• stitch Width: To suit button
• Stitch Length: 0
• Needle Plate Raising Shim (with modell 9518)
• Snap-in Feed Cover (with modell 9618)
• General Purpose Foot
ATTACHING A BUTTON
Flat buttons can be sewn on by machine
using the zig-zag stitch.
• Insert needle plate raising shim as
instructed on page. 11 (Snap-in Feed
Cover with 9618 Model).
1. Set stitch width selector at 0.
• Set needle position at left ¿m .
• Place button positioned on fabric under
foot and lower needle into centre of left
hole.
• Lower presser foot.
• Turn hand wheel toward you until the
needle rises out of button hole and is
just above the presser foot.
2. Set stitch width selector to a medium width
zig-zag setting.
• Continue turning hand wheel until the
needle is above right hole, adjust stitch
width, as necessary, until needle enters
the centre of the right hole.
• Take six or more zig-zag stitches and fin­
ish with the needle on the left.
3. Move stitch width selector to 0 and take a
few stitches to fasten threads.
• Pull thread ends through to back of gar­
ment knot close to fabric and snip off
loose ends of thread.
63