SINGER 9618 User Manual
Page 73
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING BOBBIN CASE
Raise needle, open slide plate, remove needle
plate and lift out bobbin.
Turn bobbin case holder A to back as far as it
will go.
Lift out bobbin case B.
REPLACING BOBBIN CASE
Insert bobbin case with a back and forth
motion, so that front of the case is under the
position plate C. Turn holder all the way
iforward to lock bobbin case.
Replace needle plate and close slide plate.
CHANGING THE LIGHT BULB
CAUTION: Before changing light bulb make sure
you have disconnected power line plug from
socket outlet
CAUTION: This machine is designed to use a 15
watt maximum bayonet base bulb
only.
1. Removing Bulb
• With thumb of right hand push in and down
on tab of light lens and lower the light
bracket.
•
Do not attempt to unscrew the bulb.
• Press it up into the socket and at the same
time turn bulb over in direction shown to
unlock the bulb pin and guide out of socket.
Replacing Bulb
Press new bulb into socket, with bulb pins
entering slots of socket.
Turn it over in direction shown to lock bulb
in position.
Push entire assembly up until it snaps in
position.
71