Darnimfi – SINGER 201 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
' ^ \
a
' '■■.'i >
j
’'
;.
DARNIMfi
!. V '*c i;.'o'. ^
%i ^^■ ; „
Turn machine back on its hinges. Un
screw the thumb screw P2, Fig. 2 8
out of the lower hole A in the crank
Q2 until the crank Q2 is released.
Move feed lifting crank Q2 downward
so that thumb screw P2 will enter
upper hole B. Insert thumb screw P2
in this hole and tighten firmly. The
feed is thus rendered inoperative and
will not interfere with the free move
ment of the work. Bring machine for
ward into place.
Move stitch regulating lever W, Fig.
2 0, page 1 8 to its neutral position in
the center of slot at front of machine.
Remove presser foot and let down
presser bar lifter G, Fig. 19, page 17
to restore tension on needle thread
which is released when lifter is raised.
Draw up bobbin thread as instructed on
page 16.
30