SINGER 201 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
foot. Turn machine back on its hinges
and turn thumb screw P2, Fig. 28,
page 30 out of upper hole B, Fig. 28
in feed lifting crank Q2, Fig. 28, and
into lower hole A, Fig. 28. Make sure
that thumb screw is firmly tightened.
Bring machine forward into place, re
turn stitch regulating lever W, Fig. 2 0,
page IS, to its original position and
the machine is ready for regular stitch
ing. Stockings and socks, underwear,
etc., can be more conveniently darned
on the machine with the SINGER*
DARNING and Embroidery Attach
ment 160720 (page 68).
Embroidering:
Prepare the machine the same as for
darning as instructed on page 30, with
the following exceptions—
For surface embroidery, remove the
presser foot to give a clear view of the
stitching in process.
For lace embroidery remove the regular
presser foot and replace with Foot
160858 or with Darning and Embroidery
Attachment 160720, either of which
can be purchased from any SINGER
SEWING CENTER or from any
SINGER Salesman. See instructions on
page 68.
32