To insert lace or ribbon, To pipe with edge-stitcher – SINGER 201 User Manual
Page 54
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Adjust lug D2 until edges to be
joined are caught by the stitching.
3. Slightly overlap edges of lace while
stitching to keep them against ends
of slots.
4. Loosen both thread tensions to avoid
puckering of fine lace.
To Insert Lace or Ribbon
1. Fold edge of material to which lace
or ribbon is to be sewn and insert it
in slot 1, Fig. 54 of edge-stitcher.
2. Insert lace or ribbon in slot 4 of
edge-stitcher and proceed to sew.
3. Cut away surplus folded material
close to stitching.
To Pipe with Edge-Stitcher
1. Cut piping bias and twice width of
slot 3 so that it can be folded once.
2. Insert piping
w i t h
i t s
folded edge
to left in slot
3 and edge
to be piped
in s l o t 4 ,
Fig. 54.
Fig. 56. Setting in Lace Insertion
Fig. 57. Piping with
Edge-Stitcher
53