Piping and binding in one operation – SINGER 201 User Manual
Page 50
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
stitching about midway of folded
binding.
Crease raw edges of garment toward
wrong side about H inch, and insert
folded edge, raw edges uppermost, into
edge guide on binder, and beneath
binding.
When stitched, both sides of garment
will be finished, and right side will
show piped edge.
Piping and Binding in One Operation
A garment can be piped and bound in
one operation, as shown in Fig. 51.
IMPORTANT:
When
piping
and
binding at same time, as shown in Fig.
51, insert narrow width of binding
first in its slot, then insert wider
width in its slot. Two consecutive
widths should not be used at same
time. That is, if No. 1 is used, wider
binding should not be smaller than No.
3. If No. 2 is used, wider binding
should not be less than No. 4. Never
use Nos. 1 and 2, or 2 and 3, etc.,
together.
Use the upright guide pins to guide the
wider of the two widths of binding, as
shown in Fig. 51.
Fig, 51. Piping and Finding in One Operation
49