To adjust ruffler for pleating – SINGER 201 User Manual
Page 62
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Piping material is usually cut on the
bias and it should be about 3^ inch
wide when folded in center. Place
piping material in rufiler, following
Line 5, Fig. 70 with folded edge of
piping to the right.
3. Fold edge of material to which pip
ing and ruffling are to be attached
and insert it in rufiler, following
Line 6, Fig. 70.
To Adjust Ruffler for Pleating
1. Raise adjusting lever E and move it
until projection D can be entered in
slot marked “6”. The rufiler will
then pleat once every six stitches. To
pleat once every 12 stitches, have
projection D enter slot “12” in ad
justing lever E.
2. Insert material to be pleated between
two blue blades Line 2, Fig. 72.
MATERIAL
Fig. 71, Piping a
Fig. 72. Correct Position for Material
61