To make hems, From 3/16 to 15/16 inch wide – SINGER 201 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
■
'
■
> . .■■ i ■ 1 /■'.
„ <•
To Make Hems
from 3/16 to 15/16 Inch Wide
1. Attach adjustable hemmer to presser
bar in place of presser foot.
2. Pull up bobbin thread, as instructed
on page 16.
3. Loosen thumb screw on hemmer and
move scale until pointer registers
with number of desired width of
hem. (No. 1 indicates the narrowest
hem and No. 8, the widest.) Then
tighten thumb screw.
4. Place cloth in hemmer and draw it
back and forth until hem is formed,
as shown in Fig. 46.
5. Draw end of hem back under needle,
lower presser bar and start to sew.
6. Guide sufficient cloth into hemmer to
turn hem properly.
Fig 46. Mutking Hem Up to Inch Wide
With Adjustable Hemmer
45