Attaching a button – SINGER 6215 User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ATTACHING A BUTTON

Flat buttons can be sewn on quickly and easily using the plain zig-zag stitch.

A special button sewing foot (H), may be purchased at your sewing center.

RECOMMENDED SETTINGS

Stitch Selection: Zig-Zag Stitch #4

Needle Position:

J,

Stitch Width: To suit Button

Foot: Button Sewing (H)
Needle Plate: General Purpose (A)

Attach Feed Cover (F)

Before you can attach a button, the

bobbin thread must be brought up

through the hole in the feed cover.

1

. Set stitch width at , and needle

position selector at ^ Position

button under foot and lower the

needle into the center of the left

hole. Lower the foot. Turn hand
wheel toward you until needle
rises out of button and is above the

foot.

2. Move stitch width selector until

needle is over the other hole in the

button. Then, when you begin to

stitch, the needle should enter into

the right hole of the button. Take six

or more zig-zag stitches to attach
button and finish with the needle on
the left side.

3. To fasten stitching, adjust width to

( i ), and take three or four

stitches.

Remove

work,

d r a w

threads to underside, fasten, and
trim.

Advertising