Changing snap-on presser feet (b),(d),(j),(l), Changing screw-on presser feet (h),(g) – SINGER 6215 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING SNAP-ON PRESSER FEET (B),(D),(J),(L)
Your machine comes with the General Purpose Presser Foot (B) already attached.
You can easily change to any one of the other presser feet which snap onto a com
mon shank by following the directions below.
Raise needle to its highest position
by turning hand wheel toward you.
Raise presser foot using presser foot
lifter at back of machine.
Push toe of presser foot (1) up, until it
snaps off the shank (
Remove foot from machine.
Place new foot under center of
• Lower presser foot lifter, fitting shank
over presser foot pin (3).
Don't turn screw. Instead, push
presser foot screw (4) down, firmly
until foot snaps into place.
CHANGING SCREW-ON PRESSER FEET (H),(G)
Some special presser feet can be purchased at your sewing center which have built-
in shanks that can be replaced as follows:
• Raise needle and presser foot.
• Loosen presser foot screw (1) and
remove presser foot with shank (
guiding it toward you and to the right.
• To replace presser foot with shank,
hook shank around the presser bar
and tighten presser foot screw with
the use of a coin.