Cino FA470 - Manual (Page 60)

Command Descriptions
2-45
Remote Programming Extension
(WF)
Descriptions
Enter remote programming mode with user defined message, beeps and vibration.
Wi-Fi scanner can only perform Remote Control commands when it is not in Programming mode.
Remote Programming Extension (Enter) is used to put scanner into programming mode, so that
the subsequent programming commands will take effect. Please refer to Briefing Chapter (Page 1-2)
for detailed descriptions.
Note that in programming mode the scanner can not work until the Remote Programming (Exit) or
Remote Programming Extension (Exit) is sent.
Available for F & L series
Packet Format
Prefix Opcode Status Length Parameter(s) LRC Suffix
7Eh 80h 90h 06h 00h 02h 00h See Next Page Variable 7Eh
1 Byte 3 Bytes 1 Byte 2 Bytes 512 Bytes 1 Byte 1 Byte
. Host Requirements
If the device successfully received the above command issued by the host, a “Device ACK” will be sent
to the host right after the device performed the action. Otherwise, a “Device NAK” will be sent to host to
issue a command error. However, if the host can not receive any response from the device within the
user preset time-out duration, please resend the above command.
. Length
Total size (bytes) of the Parameter(s) field
. LRC
”Opcode” XOR “Status” XOR “Length” XOR “Parameter(s)”