Labconco Protector XL Floor-Mounted (Walk-In) Laboratory Hoods 98606 User Manual
Page 15
11
Product Service 1-800-522-7658
C
C
H
H
A
A
P
P
T
T
E
E
R
R
3
3
G
G
E
E
T
T
T
T
I
I
N
N
G
G
S
S
T
T
A
A
R
R
T
T
E
E
D
D
Now that the site for your Protector XL Floor-Mounted
(Walk-In) Hood is properly prepared, you are ready to
unpack, inspect, install, and certify it. Read this chapter
to learn how to:
• Unpack and move your Protector XL Floor-
Mounted Hood.
• Set up the floor-mounted fume hood on the
floor.
• Connect to an exhaust system.
• Connect the electrical supply source.
• Connect the service lines.
• Sealing the Protector Hood to the floor.
• Arrange certification of your Protector Hood.
Depending upon which model you are installing, you
may need common plumbing and electrical installation
tools in addition to 5/16", 3/8", 7/16", and 1/2"
wrenches, ratchets, sockets, a nut driver set, a flat-blade
screwdriver, a Phillips screwdriver, and a carpenter
level to complete the instructions in the chapter.
The Protector XL Floor-Mounted
Hood models weigh between 700 to
3500 lbs. (318-1593 kg). The shipping
skid allows for lifting with a
mechanical lift truck or floor jack. If
you must lift the fume hood manually,
follow safe-lifting guidelines.
!