Labconco Protector XL Floor-Mounted (Walk-In) Laboratory Hoods 98606 - Manual (Page 29)

25
Product Service 1-800-522-7658
Chapter 3: Getting Started
Header Installation for the
Floor-Mounted Hoods
The header is shipped separately in its protective
packaging. To install, the header is fastened to the
corner covers by four #12 screws. Reach behind the
corner posts from the side and install the screws to
support the header. See Figure 3-8.
Figure 3-8
Front Panel Installation for
the Floor-Mounted Hoods
The hood front panel(s) is shipped separately and is
protected. To install each panel, hang the two plastic
cylinders on the backside of the front panel over the
corner posts and center support (10', 12', 16' models).
The bottom of the front panel will then slip behind the
header once it has been properly secured at the top. See
Figure 3-3.
#12 Screws
Corner Post
Header