Labconco Protector XL Floor-Mounted (Walk-In) Laboratory Hoods 98606 - Manual (Page 31)

27
Product Service 1-800-522-7658
Chapter 3: Getting Started
The identification plate, model number, serial number,
and electrical connection boxes are accessible from the
front of the fume hood by removing the front panel.
The Protector XL Floor-Mounted Hood is normally
wired for 115 Volt, 60 Hz, 20 Amp or 230 Volt, 50 Hz,
10 Amp electrical service. Check the I.D. plate behind
the front panel for voltage verification. The number of
circuits varies depending on the model. All of the
electrical connections are terminated at the single point
internal junction box for hook-up by a qualified
electrician. The single point internal junction box is
used for the connection of the lights, blower, and
duplex outlets.
Refer to the wiring diagram for your Protector Hood in
Appendix C: Protector Fume Hood Specifications.
Figure 3-9
All wiring for the fume hood
SHOULD be performed by a licensed
electrician, and conform to all local
codes. In most cases, the hood will
require the use of shielded conduit to
protect the wiring into the hood. The
Internal Junction
Box