Labconco Protector XL Floor-Mounted (Walk-In) Laboratory Hoods 98606 User Manual
Page 25
21
Product Service 1-800-522-7658
Chapter 3: Getting Started
Figure 3-5
Horizontal-Sliding Sash
Installation for the 8', 10',
12', & 16' Floor-Mounted
Hoods
The Floor-Mounted Hood with horizontal-sliding
sashes is supplied with four individual sash doors.
These doors have been packaged separately during
shipment and require installation in the field. The doors
should not be installed until the lower sash track
threshold has been properly installed. Each door
assembly is provided with two mounting brackets with
nylon roller bearings. The roller bearings have been
positioned in the center location of each mounting
bracket to provide for maximum door adjustment. The
upper header sash track features two tracks that will
support two of the door assemblies. Raise the door
panel up and into the upper track section on your hood
and place the nylon roller bearings directly in the track
section. At the same time, position the bottom edge of
Threshold Support Bracket
Rear Ramp
Lower Sash Track Threshold
Front Ramp
H