Labconco Protector XL Floor-Mounted (Walk-In) Laboratory Hoods 98606 - Manual (Page 19)

15
Product Service 1-800-522-7658
Chapter 3: Getting Started
Upper Cabinet Installation
of the Protector XL Floor-
Mounted Hood
Remove the upper cabinet assembly side panels and
front panels prior to cabinet placement. Then place the
upper cabinet assembly on top of the lower base
assembly, being careful to clear the lower base
assembly during placement. To prevent spillage from
seeping between the two liner assemblies, run a bead of
white RTV sealant between the sections once they have
been properly aligned. Mount the lower base to the
upper cabinet using the ¼-20 hex head screws,
lockwashers, and nuts included in your hood package.
See Figure 3-2.
Figure 3-1
Upper Cabinet Assy.
Lower Base Assy.
Rear Vertical
Sash
Front Vertical
Sash
Apply bead of RTV
at inner joint.