Labconco Protector XL Floor-Mounted (Walk-In) Laboratory Hoods 98606 User Manual
Page 18
14
Product Service 1-800-522-7658
Chapter 3: Getting Started
NOTE: THE SASH WEIGHT IS MATCHED
FOR THIS MODEL OF HOOD AND
SHOULD NOT BE EXCHANGED WITH
ANY OTHER UNIT.
Disassembly and
Reassembly of the
Protector XL Floor-Mounted
Hood
There may be some disassembly and reassembly work,
due to the large physical size of your laboratory hood
and the ability to maneuver it into your laboratory.
This is specific to each customer.
Lower Base Installation of
the Protector XL Floor-
Mounted Hood
The lower base features a panelized liner surrounded by
an epoxy-coated steel and galvanized steel framework.
Both the left and right side panels should be removed to
allow for the correct placement of the lower cabinet
assembly. Temporarily remove both vertical-rising
sashes shipped with the lower base (on vertical-rising
sash models only). Position the lower base on a level
floor surface. Place the vertical-rising sashes back in
place (on vertical-rising sash models only).
NOTE: If an optional floor surface is purchased, it
should be positioned on the existing floor prior to
placement of the lower cabinet installation. See Figure
3-1.
)
V