Labconco Protector XL Floor-Mounted (Walk-In) Laboratory Hoods 98606 - Manual (Page 16)

12
Product Service 1-800-522-7658
Chapter 3: Getting Started
Unpacking Your Protector
XL Floor-Mounted Fume
Hood
Your Protector XL Floor-Mounted (Walk-In) Hood has
been shipped to you as ten main component assemblies
located on three shipping skids. The ten main
component assemblies consist of the lower base, upper
cabinet, sashes, lower sash track, corner posts, service
fixtures, electrical connections, baffles, header, and
front panel.
Carefully remove the shrink-wrap on your three
shipping skids, and inspect it for damage that may have
occurred in transit. If your unit is damaged, notify the
delivery carrier immediately and retain the entire
shipment intact for inspection by the carrier.
DO NOT RETURN GOODS
WITHOUT THE PRIOR
AUTHORIZATION OF LABCONCO.
UNAUTHORIZED RETURNS WILL
NOT BE ACCEPTED.
IF YOUR FLOOR-MOUNTED HOOD
WAS DAMAGED IN TRANSIT, YOU
MUST FILE A CLAIM DIRECTLY
WITH THE FREIGHT CARRIER.
LABCONCO CORPORATION AND
ITS DEALERS ARE NOT
RESPONSIBLE FOR SHIPPING
DAMAGES.
Do not discard the shipping skid or packing material for
your fume hood until you have checked all of the
components and installed and tested the unit.
Do not remove the fume hood from its shipping skid
until it is ready to be placed into its final location.
Move the unit by placing a flat, low dolly under the
shipping skid, or by using a floor jack.
The United States
Interstate Commerce
Commission rules
require that claims be
filed with the delivery
carrier within fifteen (15)
days of delivery.
)
)