Xblue Networks X-50 - Manual (Page 159)

XBLUE Networks 159
Wireless Programming
Adv
anced
8
•
Channel is adjustable from “Auto” and 1 - 11
•
Automatic Channel Timer (min) - Number of minutes between spectrum scans.
•
When “Channel” is set to Auto, the X-50 searches for the best channel in the specified timeframe.
•
802.11n/EWC - This setting automatically uses 802.11n support or disables it.
•
Auto or Disable
•
Bandwidth - The administrator can select to use both 20 and 40MHz or restrict it to 20MHz in 2.4G band
and 40MHz in 5G band.
•
20MHz or 40MHz or 20MHz in 2.4G Band and 40MHz in 5G band
•
Control Sideband - If 40MHz is selected - The administrator must select between upper and lower sidband.
•
Upper or Lower
•
802.11n Rate - Select a specific data rate or select auto to allow the system to determine the best rate.
This is only applicable when 802.11n/EWC is set to auto.
•
Auto, use 54g Rate, 6.5, 13, 19.5, 26, 39, 52, 58.5, 65, 78, 104, 117, and 130 Mbps.
•
802.11n protection - used to improve 802.11n performance in a mixed 802.11b and 802.11g protocols.
Turn this feature off to maximize throughput, but disables all other protocols.
•
Auto or Off
•
802.11n Support Client Only - Select “Off” to allow other wireless devices 801.11b and 802.11g to connect
to the system. Select “On” to allow only 802.11n clients to connect to the system.
•
Off or On
•
54g
®
Rate - Select the data transfer rate speed from 1 to 54Mbps. Auto, will allow the system to determine
the best transfer rate.
•
Auto, 1 Mbps through 54 Mbps.
•
Multicast Rate - Transmit rate
•
Auto (1, 2, 5.5, 11, 12, 18, 24, 36, 54 Mbps)
•
Basic Rate - transmit rate - Select the basic rate that a client must support
•
Default (All, 1, 2, 5.5, 6, 11, 12, 24 Mbps)
•
Fragmentation Threshold 2346
•
The X-50 allows the administrator to set the maximum frame size the wireless device can send
without fragmenting the frame. This setting is rarely changed. The default setting is the maximum
frame size of 2346, which means that it will not fragment any frames that it sends to wireless
clients. This setting is best for most environments.
•
RTS Threshold 2347
•
RTS/CTS frames packet size threshold once exceeded RTS/CTS is sent.
•
DTIM Interval - Delivery Traffic Indication Message - Informs the clients about the presence of buffered
multicast/broadcast data on the access point.
•
The default value is 1 and it can be set from 1 to 255 ms.
•
Beacon Interval - Beacon Frames are transmitted to periodically announce the presence of a wireless LAN.
•
The default value is 100 and it can be set from 1 to 65535.
•
Global Max Clients - This is the maximum number of wireless clients for all established wireless networks.
•
XPress
®
Technology
•
Enable this feature to improve wireless performance.
•
Transmit Power 100% (20%, 40%, 60%, 80%)