CIRCUTOR CDP-0 - Manual (Page 38)

CDP
38 Instruction Manual
5.- DISPLAY AND CONFIGURATION
5.1. MEASURES MENU
The following screen sequence appears when you select the “Measures” option:
1- If the unit is configured in single-phase, the voltage and current for each
of the phases are displayed on this screen, the resolution is set with one decimal
place:
Figure 36: First screen of the measures menu in single-phase mode.
If the unit is configured in the three-phase, mode, the average of the
voltage and current for each of the three phases is displayed in the first
column, the resolution is set with one decimal place:
Figure 37: First screen of the measures menu in three-phase mode.
2- If the unit is configured in single-phase mode, the inductive reactive
power and voltage and three-phase capacitive power are displayed in the first
column, the resolution is set with one decimal place:
Figure 38: Second screen of the measures menu in single-phase mode.
If the unit is configured in three-phase mode, the inductive reactive
power and three-phase capacitive power are shown in the first column,
the resolution is set with one decimal place:
Figure 39: Second screen of the measures menu in three-phase mode.
Note: A negative sign indicates that the direction of the current is inversed.
3- Consumed active energy:
US corresponds to the user's energy, GR is the energy from the grid and
PV is that from the inverter.
The units are kWh and the resolution is set with one decimal place: