C. nutap-s61 hyperterminal command – mode, D. nutap-s61 hyperterminal command – monitor – Xtramus NuTAP-S61 V1.2 User Manual

Page 29

Advertising
background image


29

XTRAMUS TECHNOLOGIES

®

. NuTAP-S61 HyperTerminal Command – mode

C

Command Descriptions – mode

show

The mode show command allows you to view NuTAP-S61’s redirect mode
(aggregation, segregation, or multi-mirror) settings.

mode

set

The mode set [aggregation | segregation | multimirror] <m0 | m1> command
allows you to set NuTAP-S61’s redirect mode for Monitor Port M0/M1. For example, to
set NuTAP-S61 Monitor Port M0 to aggregation redirect mode, please input the
command “mode set aggregation m0”.

D. NuTAP-S61 HyperTerminal Command – monitor

Command Descriptions – monitor

show

The monitor show command allows you to view header and media type for all
NuTAP-S61’s ports (Network Port A0/A1 and Monitor Port M0/M1).

The monitor [m0 | m1 | port=all] header [da | sa | id | dip | sip | dport | sport | mtu]
<Parameter>
command allows you to configure NuTAP-S61’s Monitor Ports M0/M1.
The configuration options available includes:

DA: Destination Address

SA: Source Address

ID: ID

DIP: Destination IP Address

SIP: Source IP Address

DPORT: Destination Port

SPORT: Source Port

MTU: Maximum Transmission Unit

For example, to set NuTAP-S61 Monitor Port M0’s destination port to port 9, please
input the command “monitor m0 header dport 0009”. The formats for each available
configuration option are listed down below:

DA/SA: XX-XX-XX-XX-XX-XX

ID: XXXX

DIP/SIP: XXX.XXX.XXX.XXX

DPORT/SPORT: XXXX

mode

The monitor [m0 | m1 | port=all] header mode command allows you to set
the combinations of headers that will be added to packets to/from designated
Monitor Port (MAC, ID, Timestamp, IP, Port, Fragment). For example, to add
the header with ID and IP to packets to/from Monitor Port M0, please input the
command “monitor m0 header mode id+ip

monitor

header

reset

The monitor [m0 | m1 | port=all] header reset command allows you to reset
all settings made to the specific Monitor Port. For example, to reset all settings
done for Monitor Port M0, please input the command “monitor m0 header
reset
”.

E-mail: [email protected]

Website: www.Xtramus.com

Advertising
This manual is related to the following products: