Beisler 1911-4 - Manual (Page 24)

Short Seam Automat 1911-4 / 1912-4 Working Instructions
- B 24 -
Beisler Automated Sewing Equipment
B.3
Operation
B.3.8 Aligning sewing pieces
Alignment using the "Photocell" function,
Version 1911-4:
If the "Photocell" function is enabled, the sewing piece is
aligned to the stop rail and to the guide laser.
1. Open bundle clamp. Depress and hold footswitch for
bundle clamp while the sewing pieces are sorted and
prepared in the bundle clamp.
2. Close bundle clamp, release footswitch.
3. Fig. 10: Align sewing piece for parallel orientation of
seam to the long side of the stop rail 2. To ensure the
correct end point of the seam, line up sewing piece ex-
actly at the red marking line 3 of the guide laser.
NOTE - Reflective stripe!
The position of the main clamp to the sewing piece is
determined by photocells. The photocells respond to light
that is reflected by a reflective stripe 1. If the reflective
stripe is obscured, a machine failure may occur. The reflec-
tive stripe must always be visible!
Fig. 10
Fig. 10