Beisler 1911-4 - Manual (Page 63)

- D 63 -
Short Seam Automat 1911-4 / 1912-4 Working Instructions Beisler Automated Sewing Equipment
D.2
Fundamentals of programming
D.2.1 Program control layout
Setting seam number using handwheel
Fig. 02: The handwheel
1 of the clamp must be set to
the number of the seam that is to be effected first, i.e. the
left number in the line of seam numbers displayed.
Factory setting
The machine comes with a factory-installed standard pro-
gram (M 01) with four seams (01, 02, 03, 04) of different
stitch widths.
Tab. 01: The numbers on the handwheel are assigned
to the seam numbers.
Access to menus
The following menus are freely accessible:
•
Service menu,
• Global parameter menu,
• Special parameter menu.
Except for three submenu pages, the entire system menu
is controlled by access privileges. These privileges pro-
tect the system menu from unauthorized access. Data
cannot be entered and the system menu cannot be mo-
dified unless the service code has been entered. This code
is contained in the documentation delivered with the
machine.
Menu level structure
The program control is divided into six menu levels (start
level and levels 1-5).
The system menu is requested from the start level. The
remaining operator prompting is achieved with plain text
in the submenus.
The service menus are requested directly from the start
level and from level 1.
The global parameter menu is requested from level 1,
the parameters pertaining to the menu are selected and
changed in a list.
The special parameter menu is requested from level 1
and is edited in four other levels (levels 2-5) and in the per-
taining parameter lists.
CAUTION - Damage to machine!
Some of the menu entries start machine units or a
machine cycle.
This may damage machine components if the machine
is not ready for operation.
Do not enter data unless the machine is ready for
operation.
Fig. 2
Fig. 2
1
1
Handwheel Seam number Stitch width
1 01 30 mm
2 02 32 mm
3 03 35 mm
4 04 37 mm
Seam number assignment on handwheel