Beisler 1911-4 - Manual (Page 85)

- D 85 -
Short Seam Automat 1911-4 / 1912-4 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3.10 Level 2 special parameters / Lists
Switching swivel stamp mode (1912-4):
The ejector stamp supports the sewing piece transport
upon blowoff by performing a quarter-circle swivel. For the
transport of light sewing pieces, the ejector stamp can be
switched off.
To enable or disable this function:
:
• Press
 key.
Switching swivel stamp mode
NOTE - Enable function!
These parameters can only be set if the function "Switching
swivel stamp" is enabled.
:
(D.4.5 Level 3 special parameters / Functions)
The Switching swivel stamp does not swivel.
•
Mode 01: After tucking, the Switching swivel stamp is
lowered, fixes the sewing piece and swivels in accor-
dance with the time values programmed in positions
30 and 31 of the global parameter list.
Setting upper part parameters:
This list is used for setting all parameters for functions of
the sewing head.
The minimum and maximum values of input are limited
by the program control unit. Values that are not within the
limits will not be accepted but reduced to the correspon-
ding minimum or maximum value.
• Press
? key.
The parameter list is shown on the display.
NOTE - Sewing speed!
Possible settings for the sewing speed refer to the follo-
wing sewing ranges:
06
sewing speed 1 to the start distance,
07 sewing speed 2 to the center distance,
08 sewing speed 3 to the end of the seam.
The speed is set in increments of 100 rpm.
09
distance with sewing speed 1
10 distance with sewing speed 3
12 thread monitor on after
13 top thread monitor filter
14 bobbin monitor filter
Setting stitch lengths and bar tacks:
All settings for the configuration of the seam can be chan-
ged using this list.
The minimum and maximum values of input are limited
by the program control unit. Values that are not within the
limits will not be accepted but reduced to the correspon-
ding minimum or maximum value.
• Press
3 key.
The parameter list is shown on the display.
Parameters for clamp transport:
This list is used to make all settings for the clamp move-
ment.
• Press
8 key.
The parameter list shown on the display has the following
function:
01 Clamp insertion as seen from right end of rail
02 Stop position 600 mm is a safety value. Only values
higher than 600 mm can be input
03 Settable range: 35 % - 80 %
04 Settable range: 35 % - 99 %
05 Range of the curve where no sewing is effected. If value
"0" is input here, the sewing process starts immedia-
tely.