Beisler 1911-4 - Manual (Page 41)

- C 41 -
Short Seam Automat 1911-4 / 1912-4 Working Instructions Beisler Automated Sewing Equipment
C.5
Maintenance
C.5.4 Repairs
Checking clamp travel steps:
After the toothed belt has been replaced, the number of
clamp travel steps must be checked.
At the factory, this value has been set:
•
to 50 steps at the right stop,
• to 820 steps at the left stop.
These values must be adhered to.
1. Switch machine on and allow to reference.
2. Go to diagnostics menu:
• Press  key
• Press
 key
3. Go to clamp transport menu:
• Press
 key
4. Go to clamp motor travel steps:
• Press
 key
5. Confirm safety prompt:
• Press
% key
6. Push clamp rail manually to the right stop. The display
must show 50 mm.
7. Push clamp rail manually to the left stop. The display
must show 820 mm.
Setting clamp travel steps:
If the result of the clamp travel step check is not 820 mm
for the left stop, switch S04 must be repositioned:
•
If the value is higher than 820 mm, the switch must
be repositioned to the left.
• If the value is lower than 820 mm, the switch must be
repositioned to the right.
1. Loosen two switch retaining screws.
2. Move switch in required direction and tighten screws.
3. Recheck number of clamp travel steps. If required, the
setting process must be repeated until the correct value
of 820 mm is displayed.