Compuprint 10200 Programmer Manual - Manual (Page 106)

Commands
102
DC4 DC4 ESC (GS
Prints bar code symbols (Compuprint)
ASCII Code DC4 DC4 ESC (GS n
1
data GS n
2
data ... EM
Hexadecimal Value 14 14 1B 28 1D n
1
data ... 19
Decimal Value 20 20 27 40 29 n
1
data... 25
Range 1 < n < 12
0 < p < 1
This sequence causes the bar code symbol to be printed according to the previous selection. If
you want to print more than one bar code symbol of the same type and height, GS n defines the
distance from the beginning of the line or between two bar code symbols in multiples of 1/72
inch. At the end of the line, EM must close this command.