Compuprint 10200 Programmer Manual - Manual (Page 40)

Commands
36
The m
4
parameter specifies the character width. Only the low-order half-byte is significant in
this mode byte. The high-order half-byte is ignored.
m
4
Character Width Line Spacing
0 No change No change
1 Standard width character No change
2 Double width character No change
ESC [ d
Set the print quality. (IBM 2391+ only)
ASCII Code ESC [ d 1 0 n
Hexadecimal Value 1B 5B 64 01 00 n
Decimal Value 27 91 100 1 0 n
This command sets the print quality to draft or LQ print.
n Types
0 No change
From 1 to 63 HS Draft
From 64 to 127 Draft
From 128 to 254 Letter Quality
255 Initialization on NVRAM values
If attributes are sent in the print line during the HS Draft printing, these attributes will be forced to
be printed in Draft mode.