Compuprint 10200 Programmer Manual - Manual (Page 31)

Commands
27
VT
Advances paper to the next vertical tab stop of the selected VFU channel.
ASCII Code VT
Hexadecimal Value 0B
Decimal Value 11
This code is a terminator code and when received causes the contents of the print buffer to be
printed before advancing paper to the next vertical tab stop set by the ESC B or the ESC b
commands.
This code will be executed normally, if vertical tab stops follow the current print position. It will
be executed like a FF code (EPSON mode) or like a LF code (IBM mode), if the vertical tab stops
follow the bottom of form position (which corresponds to the form length if the bottom of form
has not been set) or if the current position is beyond the last vertical tab stop. It will be executed
like a LF code if no vertical tab stops have been set by the ESC B or ESC b commands.
In EPSON mode, the vertical tabulations are referred to the VHF channel selected by the ESC /
m. If no VFU channels have been selected, the printer assumes as default channel 0.
This command resets the double width printing set by SO or ESC SO command.