Compuprint 10200 Programmer Manual - Manual (Page 13)

Commands
9
ESC 5
Sets an automatic line feed after a carriage return. (IBM)
ASCII Code ESC 5 n
Hexadecimal Value 1B 35 n
Decimal Value 27 53 n
If n is equal to 1, this command sets an automatic line feed on receiving of a CR code. If n is
equal to 0, this command cancels the automatic line feed.
n Automatic line feed
0 Disabled
1 Enabled
ESC J
Advances paper n/180 inch. (EPSON and IBMXL24AGM)
Advances paper n/216 inch. (IBMXL24 and 2391)
ASCII Code ESC J n
Hexadecimal Value 1B 4A n
Decimal Value 27 74 n
Range 1 < n < 255
This is a terminator code; it therefore causes the current contents of the print buffer to be
printed out before performing a single line feed of n/180 or n/216 inch. This command is
cancelled after the line feed has been performed. The printing will restart after a line feed from
the column at which the command was sent.