Compuprint 10200 Programmer Manual - Manual (Page 34)

Commands
30
ESC !
Sets printing style. (EPSON)
ASCII Code ESC ! n
Hexadecimal Value 1B 21 n
Decimal Value 27 33 n
This command is used to select any valid combination of the printing attributes. Each printing
attribute is selected by the n parameter, as specified in the following page:
n Attribute
0 10 cpi
1 12 cpi
2 Proportional
4 Compressed
8 Emphasized
16 Double Strike
32 Double Width
64 Italics
128 Underline
To print the desiderated combination of printing attributes, calculate the n parameter by adding
up the values of each attribute.
If attributes are sent in the print line during the HS Draft printing, these attributes will be forced to
be printed in Draft mode.