Comtech EF Data SDM-650B - Manual (Page 192)

Remote Control Operation SDM-650B Satellite Modem
B–16 Rev. 6
B.1.3.22.3 Sweep Direction
This command sets the direction of the sweep travel. “+” sets incremental sweep, while
“-” sets decremental sweep.
Command: <add/SD_s”cr””lf”]
Response: >add/SD_s”cr””lf”]
Status Only: <add/SD_”cr””lf”]
Response:
>add/SD_s”cr””lf”]
Where: s = + or - (direction of sweep travel during acquisition).
Note: This command is only valid when fast acquisition is enabled. See the “FAM_”
command definition.
B.1.3.23 Modem Operation Mode
This command configures the modem for simplex or duplex operation modes. When
transmit-only mode is selected, receive faults are inhibited. When receive-only mode is
selected, transmit faults are inhibited.
Command: <add/MOM_xxxxxxx”cr”
Response: >add/MOM_xxxxxxx”cr””lf”]
Status Only: <add/MOM_”cr”
Response:
>add/MOM_xxxxxxx”cr””lf”]
Where: xxxxxxx = TX_ONLY, RX_ONLY, or DUPLEX.
B.1.3.24 Buffer Control Mode
This command is used to enable or disable M&C buffer control.
Command: <add/BUFF_xxx”cr”
Response: >add/BUFF_xxx”cr””lf”]
Status Only: <add/BUFF_”cr”
Response:
>add/BUFF_xxx”cr””lf”]
Where: xxx = ON or OFF (OFF disables Buffer Clock, Buffer Center, and Buffer Size).
Note: For optional Doppler buffer only.