Comtech EF Data SDM-650B - Manual (Page 327)

SDM-650B Satellite Modem Trojan Interface
Rev. 5 G–31
G.6.4.4.3 Remote
Configures the modem for remote operation. The modem will respond to any status request
at any time. However, the modem must be in “Remote Mode” to change configuration
parameters.
Command: <add/REM_”cr”
Response: >add/REM_”cr””lf”]
G.6.4.4.4 Clear Stored Faults
This command is used to clear all stored faults logged by the modem.
Command: <add/CLSF_”cr”
Response: >add/CLSF_”cr””lf”]
G.6.4.4.5 Modem Operation Mode
This command configures the modem for simplex or duplex operation modes. When
transmit-only mode is selected, receive faults are inhibited. When receive-only mode is
selected, transmit faults are inhibited.
Command: <add/MOM_xxxxxxx”cr”
Response: >add/MOM_xxxxxxx”cr””lf”]
Status Only: <add/MOM_”cr”
Response:
>add/MOM_xxxxxxx”cr””lf”]
Where: xxxxxxx = TX_ONLY, RX_ONLY, or DUPLEX.