Cybex 55620H Modular User Manual
Page 116
5629 - Tandem Center Post & Dome
1
1
01779
Frame
2
2
01778
Stabilizing Base
3
8
JC782834
SHCS .50-13 x 3.00
4
4
JC780417
BHSCS .50-13 x 1.00
5 14
JS388300
Split Lockwasher .50
6 14
HN784000
Hex Nut .50-13
7
2
02216
Right Hand Magnetic Edge Guard
8
2
02217
Left Hand Magnetic Edge Guard
9 21
HT552510 Self-Tapping Phillips Screw 6-20 x .375
10 1
01776
Dome
11
2
PP080202
Plastic Insert
12
6
HS387700
Washer .50
ITEM QTY PART NO.
DESCRIPTION
Assembly Notes
1. If ceiling is less than 10 feet then install weight stacks using the long guide
rods supplied with column. Otherwise, if ceiling is greater than 10 feet then
do not install weight stacks until step 5.
CAUTION: Columns will lean with weight stacks installed.
2. Attach both columns to frame.
3. Install lower assemblies and stabilizer (item 2) to each column.
4. Install upper assemblies to each column.
5. Install weight stacks utilizing short guide rods. Attach each cable to
appropriate weight stack.
6. Route cables.
7. Attach right hand magnetic edge guard (item 7) and left hand magnetic
guard (item 8) to perforated panels using five screws (item 9) for each
magnetic strip. See PANEL ASSEMBLY TOP VIEW.
8. Install perforated panels. See INSTALLATION OF PANELS.
NOTE: The letters in the exploded-view diagram refer to the installation
of perforated panels.
9. Install upholstery.
NOTE: Hardware pack includes additional hardware required for
machines with lower pulley mount.
NOTE: This machine shipped with an Owner’s Manual. Additional copies can
be obtained by contacting your dealer or a Cybex Representative at
1-888-462-9239.