Cybex 55620H Modular - Manual (Page 61)

Cybex Modular Owner’s Manual
Page 4-7
Modular Mover
5632
TOOLS REQUIRED
• 3/8” Allen wrench
• 3/8” Allen wrench
CAUTION!! When raising or lowering modular unit, keep hands and feet clear of columns, angle
supports and frame attachments.
1. Read and understand all instructions thoroughly before performing this procedure.
2. Verify you received the items shown in Figure 1.
Assembly Instructions
A. Handle Jack ...................... 01950
B. Jack Handle
C. Modular Mover .................. 01941
D. Lifting Bracket ................... 01951
E. Hex Nut.............................. HN784000
F.
Split Lockwasher ............... JS388300
G. SHCS .500-13 x 2.75 ........ JC782832
DESCRIPTION PART NO.
3. Remove all perforated screens and set aside.
4. Remove all side stations (if applicable).
5. Install lifting bracket to the center of post using two
socket head cap screws. After tightening screws in
step 3, place hydraulic jack under lifting bracket
and raise modular unit approximately 1” off the
floor. See Figure 2.
Figure 1
Figure 2
A
B
C
D, E, F, G