Cybex 55620H Modular - Manual (Page 62)

Cybex Modular Owner’s Manual
Page 4-8
6. Install lift dolly and tighten in place using T-handle on dolly. See Figure 3.
7. Repeat step 4 for each remaining position around the modular unit. NOTE: If a leg Curl/Leg
Extension is next to an O.C. Cable Column, then do not install lift dolly in this position.
8. After lift dollies have been secured in place, the modular unit can be lowered and the hydraulic
jack can be removed.
9. Move modular unit to desired location. NOTE: When moving modular unit be sure to support any
pieces attached to the columns.
10. Position modular unit as desired. Install hydraulic jack and raise unit. Remove lift dollies and
lower modular unit.
11. Remove lifting bracket from center post.
12. Reattach any side stations.
13. Reattach perforated screens to the modular unit. Be sure screens are secured.
Figure 3