Flowserve DDC-100 Master Station II - Manual (Page 11)

FCD LMAIM5001-00 DDC-100 Master Station II Installation and Operation Manual 11
Flow Control Division
Limitorque Actuation Systems
3
Quick Startup
3.1 Single Master Station Quick Setup Instructions
1. Connect power, earth ground, and network cables per Flowserve recommendations.
2. Turn power on to the Master Station.
3. Wait for the Master Station display to illuminate and the “Press Anywhere To Begin” message.
4. Press the screen and enter the configuration password when prompted. Select Enter.
5. Next select “Configure” then “MOV network”. Select the network baud rate, Time-out, retries, adjust
the Propagation delay and RTS ON delay if required. Next activate the appropriate number of
networked MOVs by making the lamp beside the address green.
6. Select the Back button until the Configuration screen is displayed.
7. From the Configure screen, select “DCS Port.” Select the desired baud rate, stop bits, parity and
electrical standard. Select Next and configure the Master Station DCS port address, adjust the RTS
ON Delay and RTS OFF Delay if required. Select Next for the “Configure DCS Data Table screen”.
8. Configure the data tables for the Master Station.
9. To create the Holding register data table (40000 register block for MOV status) for the Master
Station, select Modbus Fc 03. Select the MOV registers to be available for the DCS by pressing the
toggle switch to illuminate the “green light” on the switch. View the selections and save the changes
and return to the “Configure DCS Data Table” screen.
10. To create the Coils data table (0000 register block for forcing and reading coils) for the Master
Station, select Modbus Fc 05/15. Select the MOV Coils to be available for the DCS by pressing the
toggle switch to illuminate the “green light” on the switch. Save the changes and return to the
“Configure DCS Data Table” screen. Note this feature also creates the Modbus Fc 01 (Read Coils)
data table.
11. To create the Holding register data table (45000 register block for writing holding registers) for the
Master Station, select Modbus Fc 06/16. Select the number of write registers for the MOVs to be
available for the DCS by pressing the toggle switch to illuminate the “green light” on the switch. View
the selections and save the changes and return to the “Configure DCS Data Table screen.”
12. Select Back until reaching the “Configure” screen. Select Back and when prompted to Save,
Select Yes.
13. This will permit a rapid configuration of the Master Station. Further adjustments may be made by
following the procedures outlined in the Master Station Manual.
3.2 Hot Standby Master Station Quick Setup Instructions
Connect power, earth ground, and network cables per Flowserve recommendations.
3.2.1 Configure the Left CPU
1. Turn on power to the left processor of the Master Station. DO NOT apply power to the right half of
the Master Station.
2. Wait for the Master Station display to illuminate and the “Press Anywhere To Continue” message.
3. Press the screen and enter the configuration password when prompted. Select Enter.