Flowserve DDC-100 Master Station II - Manual (Page 2)

2 DDC-100 Master Station II Installation and Operation Manual FCD LMAIM5001-00
Flow Control Division
Limitorque Actuation Systems
Master Station
Installation and Operation Manual
©2004 Copyright Flowserve Corporation. All rights reserved.
Printed in the United States of America.
Disclaimer
No part of this book shall be reproduced, stored in a retrieval system, or transmitted by any means,
electronic, mechanical, photocopying, recording, or otherwise without the written permission from
Flowserve. While every precaution has been taken in the preparation of the book, the publisher assumes
no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the
use of the information contained herein.
This document is proprietary information of Flowserve furnished for customer use ONLY. No other uses
are authorized without written permission of Flowserve.
Flowserve reserves the right to make changes, without notice, to this document and the products it
describes. Flowserve shall not be liable for technical or editorial errors or omissions made herein; nor for
incidental or consequential damages resulting from the furnishing, performance or use of this document.
This manual contains information that is correct to the best of Flowserve’s knowledge. It is intended to be
a guide and should not be considered as a sole source of technical instruction, replacing good technical
judgment, since all possible situations cannot be anticipated. If there is any doubt as to exact installation,
configuration, and/or use, please contact Flowserve at 1-800-225-6989.
The choice of system components is the responsibility of the buyer, and how they are used cannot be the
liability of Flowserve Corporation. However, Flowserve’s sales team and application engineers are always
available to assist you in making your decision.
MS-DOS ® is a registered trademark of Microsoft Corporation.
IBM-PC ® is a registered trademark of International Business Machines Corporation.
Belden ® is a registered trademark of Belden, a division of Cooper Industries, Inc.