Channel supervisor, Channel alert, Channel monitor – GAI-Tronics ICP9000 Navigator Series Console Operator's Manual User Manual
Page 30: One-touch paging
Standard Feature Operation
ICP9000 Navigator Series Console Operator’s Manual
12/10 30
It is not possible to execute a channel frequency change while selecting a radio-patch, multi-select,
frequency or multi-PL.
Channel Supervisor
The channel supervisor feature allows supervisor control to be activated or deactivated on a channel at
any time in all modes of operation without first selecting the channel. While the channel has supervisor
mode activated, the border of the channel supervisor button will light. For more information on
supervisor operation, see Activating Supervisor Control in the Options section of this manual.
Channel Alert
The channel alert feature can be programmed to generate one of the four available alert tones on a
particular channel at any time during most modes of operation without first selecting the channel. The
channel alert buttons behave exactly like the four alert tone buttons. While the channel alert is activated,
the border of the channel alert button will light. To extend the talk-time, press and hold the main
TRANSMIT
button or the channel’s
TRANSMIT
button. To end the talk-time, press and release the
channel alert, main
TRANSMIT
or channel
TRANSMIT
button. For more information on the alert tone
feature see Activating an Alert Tone on page 33 in this manual.
It is not possible to execute a channel alert while selecting a radio-patch, multi-select, frequency or multi-
PL.
Channel Monitor
The channel monitor feature allows a particular channel to be placed into monitor mode at any time
during most modes of operation without first selecting the channel. While the channel is in monitor
mode, the border of the channel monitor button will be lit. For more information on monitor operation
see Checking Channel Activity with the Monitor Button on page 31 in this manual.
It is not possible to execute a channel monitor while selecting a radio-patch, multi-select, frequency or
multi-PL.
One-Touch Paging
A one-touch paging alias can be assigned to any programmable button to allow transmission of that
paging alias at any time during most modes of operation without the need to select the proper channel. It
is important to realize that this feature is not necessarily associated with the channel on which the button
resides. Depending on the programming of the alias through the use of CARD Suite, the page may go out
on this channel or another preprogrammed channel depending on the auto-base selection in the alias. The
page may also go out on the selected channel even if the button is not on the selected channel. The
operator should consult with the system supervisor regarding the auto-selection of paging channels. For
more information on one-touch paging see One-Touch Paging in the Paging Encode section of this
manual.
It is not possible to execute a one-touch page while selecting a page, a radio-patch, multi-select,
frequency or multi-PL. It is possible to do so after the selection is complete.