GAI-Tronics ICP9000 Navigator Series Console Operator's Manual - Manual (Page 50)

Options ICP9000 Navigator Series Console Operator’s Manual
12/10 50
E&M Signaling CP0040/XCP0040
The E&M Signaling option is used to control E&M signaling stations. This type of control offers fewer
features than either tone remote or dc remote control. Consult with the system supervisor to understand
what features are available on each channel.
Buttons Not Applicable to E&M Control
If the selected channel is operating with E&M control, several features are not available. These features
include the programmable buttons, frequency buttons, monitor, secure operation and MULTI-PL. If the
operator attempts to activate any of these features, an error beep is generated.
E&M with Tone Remote Control
The E&M Signaling option supports E&M with tone remote control, which allows the features of tone
remote control to be transmitted using one radio to a receiving radio that controls the actual base station.
In this type of control, the operator may notice that there is a longer time before TRANSMIT is displayed
on the status line when the operator is allowed to make a transmission. The operator should be aware of
this added delay in transmitting to prevent the possibility clipping the first syllable of a word when
initiating a voice transmission.