GAI-Tronics ICP9000 Navigator Series Console Operator's Manual - Manual (Page 53)

ICP9000 Navigator Series Console Operator’s Manual Options
53 12/10
If the operator is using the gooseneck or internal microphone, or has activated the select speaker off-hook
override or phone patch, the audio path between the operator and the phone is forced to half-duplex.
This removes the possibility of feedback between the microphone and speaker. The operator can use the
TRANSMIT button, the headset or the handset PTT to talk to the phone caller when the half-duplex mode
is active. The operator must use the channel TRANSMIT button to transmit on any channel. While
transmitting on a console channel, the operator’s voice audio is not heard by the phone caller, but the
operator continues to hear the phone caller’s voice. To mute the phone caller’s voice, press the
PHONE
HOLD button. When on hold, the PHONE HOLD indicator is lit.
While the phone is in use, certain modes of operation may be restricted. Placing the caller on hold using
the
PHONE HOLD button will allow all console functions to be accessible and the console will operate as
if the phone were not in use. While the caller is on hold, the border indicator of the PHONE HOLD
button is lit. To take the caller off hold, press the PHONE HOLD button again. To disconnect the caller,
press the toolbar PHONE button at any time.
Auto-Dial and Last Number Redial
Auto-dial numbers can be programmed using the CARD Suite Software application. These numbers can
be used when dialing the phone by first taking the phone off-hook and pressing the
SCROLL Up/Down
buttons to select the desired auto-dial alias. When the desired alias is displayed, press the TRANSMIT
button to automatically dial the associated number.
When the phone is taken off-hook later, the last number dialed is displayed. The displayed number can
be dialed again by pressing the
TRANSMIT button. The number can be cleared by initiating a new
number with the numeric keypad or by pressing the CLEAR button.