Gasboy CFN III Manager Manual V3.6 - Manual (Page 293)

MDE-4871 CFN III Manager’s Manual for Windows® XP Embedded - Version 3.6 · August 2010 Page D-11
Messages in the Transaction Printout Status and Error Messages
Tank #X Fuel Leak
Applies only to systems connected to tank level monitors.
The tank level monitor has detected a decrease in level when in tank testing mode that could
indicate a leak.
Consult tank level monitor documentation for additional steps to take to confirm or refute
this measurement.
Leaking underground tanks can create serious environmental and health hazards.
Tank #X Probe Error
Applies only to systems connected to tank level monitors.
The tank level monitor reports trouble with probe.
Consult tank level monitor documentation.
Tank #X Excess Water
The tank level monitor reports excess water in the indicated tank.
Use the tank stick and water-detecting paste to confirm measurement. If no water is found,
consult the manual of the tank level monitor for possible causes of erroneous water readings.
Tank #X YYY Gal Delivery
The tank level monitor reports delivery of YYY gallons of product.
No action is required unless the delivery does not match scheduled deliveries.
Warm Boot
Appears on log printout when the CFN3 operating system has been reset.
Usually, no action is required. If the site was stopped before rebooting, you will require to
type a RUN command.
Messages in the Transaction Printout
The following messages may be printed in the error/status column of the transaction printout.
error #
The pump control unit sent an error code that the SC III did not recognize. Report the
problem to your service representative.