Hypertherm Shape Cutting Control - Manual (Page 30)

Edge Ti
24
Machine Interface
The information provided here is the basic information for connection of the
shape cutting control to the cutting table. Each machine interface will vary slightly
based on the cutting table configuration and features. Additionally, I/O pinout
information may vary slightly based on the configuration of the selected I/O and
their locations. Changes to the I/O configuration may be made in the password
protected I/O screen. All controls are shipped with a default selection of Inputs
and interface locations for the selected control Interface (I/O) configuration.
Installation and service should only be performed by a qualified service
technician.
The rear panel of the control has several cable connectors to connect the control
to power, I/O and communication ports. These connectors are clearly labeled as
to their function.
AC Input
The AC power cable is inserted into the AC power connector and plugged into a
standard 3-way 115 or 230 volt outlet. The AC Power connector contains an
integral fuse module and line filter. AC input power can be selected by the user
by changing position of the fuse module so that the selected voltage is displayed.
WARNING! Ensure proper orientation of fuse module for input power
before applying power to the CNC. Component damage could occur with
incorrect voltage setting.
Operation and maintenance of automated equipment involves potential hazards.
Personnel should take precautions to avoid injury. This equipment should only be
opened by trained service personnel.