Hypertherm Shape Cutting Control - Manual (Page 58)

Voyager III
52
Mating Connector
8C Phoenix Connector – Phoenix Part # 1803633
Divider PCB - 5C Connector J3 to Plasma Supply / Table
Pin # Description
1
Ground ( Chassis Ground )
2 Electrode ( Plasma DC – )
3 Work ( Plasma DC + )
4 NC
5
Shield ( Nozzle Contact )
SERCOS to Analog Conversion Card
`
Decimal Read Out
The 7 segment display indicates SERCOS ring phases status 1-4. Additionally,
the 2 decimal points in the 7 segment display indicate phase condition for the
SERCOS ring and are on immediately after CNC boot up and reset. They
remain on until the ring is successfully phased up to phase 4. After that the
decimal points remain off even if the ring drops from phase 4. With this
approach, if the SERCOS ring is not running, you can determine if the ring has
Decimal Read
RX Fiber
I/O
indicator
Drive Address
Dip Switches
Power
Status Indicator
Lights
Axis Enable
Programming
Port
TX Fiber